1D-62 Engine Mechanical:
• Apply SUZUKI SUPER GREASE to the O-ring and
press in the oil strainer to the lower crankcase.
CAUTION
!
Replace the O-rings with new ones.
NOTE
Align the boss “A” with the groove “B” of
lower crankcase.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Oil Pan
• Apply SUZUKI BOND to the mating surface of the oil
pan.
NOTE
• Make surfaces free from moisture, oil, dust
and other foreign materials.
• Spread on surfaces thinly to from an even
layer, and assemble the oil pan within few
minutes.
• Apply to distorted surfaces as it forms a
comparatively thick film.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
• Tighten the oil pan bolts.
CAUTION
!
Fit a new gasket washer to the bolt (1).
Oil Filter
• Install the oil filter with the special tool. Refer to
“Engine Oil and Filter Replacement in Section 0B
(Page 0B-12)”.
Special tool
(A): 09915–40610 (Oil filter wrench)
“A”
“B”
I717H1140167-01
I718H1140228-01
1
I717H1140168-01
(A)
I717H1140169-01
To Next Page
Loading...
