4E-27 ABS:
5) After deleting the DTCs, repeat the code output
procedure and make sure that no DTCs remain (the
ABS indicator light no longer flashes).
NOTE
If any DTCs remain, perform the appropriate
procedures, then delete the codes. If DTCs
are left stored, confusion may occur and
unnecessary repairs may be made.
6) Disconnect the mode select switch and install the left
frame cover.
7) Afterwards, ride the motorcycle at more than 30 km/
h (18.6 mile/h) and quickly apply the brakes to check
that the ABS activates correctly.
Use of SDS
1) Remove the right frame cover. Refer to “Exterior
Parts Removal and Installation (GSF650/S/A/SAK7)
in Section 9D (Page 9D-6)”.
2) After repairing the trouble, turn OFF the ignition
switch and turn ON again.
3) Set up the SDS tool. (Refer to the SDS operation
manual for further details.)
Special tool
: 09904–41010 (SDS set)
: 99565–01010–010 (CD-ROM Ver.10)
4) Click the ABS button (1).
5) Click the “DTC inspection” button (2).
I717H2450014-01
1
I718H1450054-01
2
I718H1450055-01
To Next Page
Loading...
