Clutch: 5C-16
10) Install the spring washer seat (12) and spring washer
(13) onto the clutch sleeve hub correctly.
11) Insert the clutch drive plates and driven plates one
by one into the clutch sleeve hub in the prescribed
order.
NOTE
Insert the outermost No.2 drive plate claws
“A” to the other slits “B” of clutch housing as
shown.
NOTE
For drive plate
Three kinds of the drive plate (No.1, No.2 and
No.3) are equipped in the clutch system, they
can be distinguished by the inside diameter
and paint “D”.
NOTE
For driven plate
Two kinds of the driven plate (No.1 and No.2)
are equipped in the clutch system, they can
be distinguished by the thickness. The No.1
and No.2 driven plates are 7 in total. The
driven plate No.2 should be used within 2
pcs. The driven plate No.2 should be installed
pressure plate side.
12) Install the clutch springs.
• Tighten the clutch spring set bolts to the specified
torque.
NOTE
Tighten the clutch spring set bolts diagonally.
Tightening torque
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-
ft)
14. No.3 drive plate 17. No.1 driven plate (5 – 7 pcs)
: The No.1 and No.2 driven plates
are 7 in total.
15. No.1 drive plate 18. No.2 driven plate (0 – 2 pcs)
: The No.1 and No.2 driven plates
are 7 in total.
16. No.2 drive plate “C”: Direction of outside
12 13
I718H1530051-01
“A”
“B”
I717H1530020-01
14
18
17
“C”
15
16
I717H1530021-02
Drive plate I.D. Paint “D”
No.1 101 mm (5.0 in) Black
No.2 101 mm (5.0 in) Green
No.3 108 mm (5.3 in) —
Driven plate Thickness
No.1 2.6 mm (0.10 in)
No.2 2.3 mm (0.09 in)
“D”
I717H1530035-03
I717H1530022-02
To Next Page
Loading...
