Suzuki GSX1300R - Page 300

1D-79 Engine Mechanical:
• Install the balancer cover.
NOTE
Apply a small quantity of thread lock to the
balancer cover bolt and tighten it to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Balancer cover bolt (c): 10 N·m (1.0 kgf-m, 7.0 lb-
ft)
• Remove the starter clutch cover, starter clutch and
cam chain drive sprocket.
Breather Pipe
• Install the breather pipe to the crankcase.
NOTE
Apply a small quantity of thread lock to the
breather pipe bolt and tighten it to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Breather pipe bolt (a): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Oil Strainer
• Install a new O-ring.
NOTE
Apply grease to the O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Use the new O-ring to prevent oil leakage.
• Install the oil strainer.
NOTE
Apply a small quantity of thread lock to the
strainer bolts and tighten it to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Oil strainer bolt (a): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
(c)
I815H1140061-01
(a)
I823H1140228-02
I823H1140229-01
(a)
I815H1140111-02