Engine Mechanical: 1D-80
Oil Pressure Regulator
• Apply grease to the new O-ring and press in the oil
pressure regulator to the crankcase.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Use the new O-ring to prevent oil leakage.
Oil Pan
• Install a new gasket (1).
CAUTION
!
Use the new gasket to prevent oil leakage.
• Install the oil pan and tighten the bolts diagonally.
NOTE
Fit the new gasket washer to the oil pan bolt
(2).
Tightening torque
Oil pan bolt (a): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Oil Pressure Switch
• Apply bond to the thread part of oil pressure switch
and tighten oil pressure switch to the specified torque.
NOTE
Be careful not to apply bond to the hole of
thread end.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
Tightening torque
Oil pressure switch: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
I815H1140121-01
1
I815H1140122-01
(a)
2
I815H1140123-01
I718H1140233-01
To Next Page
Loading...
