Suzuki GSX1300R - Page 303

Engine Mechanical: 1D-82
Gearshift System
• Install the gearshift cam stopper (1), bolt (2), washer
(3) and return spring (4).
• Apply a small quantity of thread lock to the gearshift
cam stopper bolt (2) and tighten it to the specified
torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
NOTE
Hook the return spring end “A” to the
stopper (1).
Tightening torque
Gearshift cam stopper bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
• Apply a small quantity of thread lock to the gearshift
cam stopper plate bolt (6) and tighten it to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (b): 13 N·m (1.3
kgf-m, 9.5 lb-ft)
• Install the gearshift shaft assembly (7) and washers
(8) as shown in the figure.
NOTE
Pinch the gearshift arm stopper with return
spring ends.
1
2
3
4
I823H1140239-02
(a)
2
“A”
1
I815H1140064-02
5
“B”
“C”
I815H1140112-01
(b)
6
I815H1140129-01
7
8
I815H1140114-01