SYSMEX CyFlow Cube 8 - Page 4

Table of contents
4 CyFlow
®
Cube 8 | Operating Manual | May 2018 | Revision 032
6 Operation ...............................................................................................24
6.1 Inserting the Software dongle.................................................24
6.2 Start-up procedure...................................................................24
6.2.1 Switching on the device .............................................................24
6.2.2 Logging in and logging out .........................................................25
6.2.3 Performing a Prime ....................................................................26
6.3 Performing a measurement.....................................................27
6.4 Performing an intermediate cleaning.....................................28
6.5 Shutdown procedure ...............................................................29
6.5.1 Cleaning for shutdown ...............................................................29
6.5.2 Switching off the device .............................................................29
6.6 Software operation...................................................................30
6.6.1 Preparing measurements using the Worklist .............................30
6.6.2 Analysing data and creating reports using the Playlist...............37
7 Troubleshooting....................................................................................39
7.1 Performing a de-bubble procedure ........................................39
7.2 Performing a de-clog procedure.............................................39
7.3 Sheath fluid, waste and fluids.................................................40
7.4 Calibration and Count Check Beads (low, medium, high) ...41
7.5 Measurements and data acquisition ......................................41
8 Cleaning.................................................................................................42
8.1 Cleaning the device .................................................................42
8.2 Performing a cleaning procedure...........................................43
9 Maintenance ..........................................................................................44
10 Disposal .................................................................................................45
11 Technical data .......................................................................................46