1Introduction
8 CyFlow
®
Cube 8 | Operating Manual | May 2018 | Revision 032
1.3 General conditions
Ensure that the following conditions are met when working with the device:
This operating manual must be read prior to using the device.
Report any recurring faults or problems to your local Sysmex
representative.
Sysmex Partec GmbH does not accept liability for any damage or personal
injury arising from:
Modifications or manipulation of the device;
Improper use;
Use of non-approved accessories;
Improper handling;
Non-compliance with this operating manual.
1.4 CE compliance
The device is marked with a CE mark of conformity, which confirms the
compliance with the essential requirements of the following European
Directives:
2014/35/EC on electrical equipment designed for use within certain
voltage limits;
2014/30/EC on electromagnetic compatibility;
2011/65/EC on the restriction of the use of certain hazardous substances
in electrical and electronic equipment.
1.5
To Next Page
Loading...