12 Software description
114 CyFlow
®
Cube 8 | Operating Manual | May 2018 | Revision 032
The Edit group contains the following buttons:
Copy: Click the button to copy an image of the currently selected plot(s)
onto the clipboard. You can then paste them into other applications
(Microsoft
®
Word, PowerPoint, etc.).
Delete: Click the button to delete the currently selected plots or region. If
the deleted plot has a region applied, deleting the plot also deletes the
region and removes the region from any gating logic. In this case, a
corresponding message box is displayed and you will have the option to
confirm or abort deleting the plot.
Select: Click the button and select an option for selecting plots:
Click the Select All Overlay Plots option to select all the plots in the
Overlays area.
Click the Select All Gallery Plots option to select all the gallery plots for
the currently selected Overlay Plot. This option is only available when
one overlay is active.
Click the Invert Selection option to select all the plots that are currently
not selected in the Overlays area or the Galleries area. This option is
only enabled if either a selection is made or when only one overlay is
active.
Click the Select All Dual Parameter Overlay Plots or Select All
Histogram Overlay Plots to select all dual parameter or all histogram
overlay plots respectively.
Fonts: Click the button to open the Edit Overlay Fonts dialogue. In the
pages of this dialogue, you can change the font typeface and size for the
region labels, plot titles, parameter names, legend/stats text and scale
labels displayed in the Overlays tab of the Workspace. The pages are the
same as in the software options (see chapter Font pages on page 192).
12.4.12 Report tab
The Report tab provides controls for creating page-based reports from a
Playlist or from a panel of a Worklist. The Report tab allows you to add and
set up report pages, insert objects and text into the report and edit and
organise the objects on the report. The reports are displayed in the Reports
tab of the Workspace (see chapter 12.8.4 Reports tab of the Workspace on
page 179).
Wizard group
The Report Wizard is only available in Playlist mode. The Report Wizard
simplifies the process of creating a report.
When creating a report via the Wizard, the current report page size and
orientation will be used, and any existing header and footer content will be
retained. Therefore, before starting the Report Wizard, set the report page
size and orientation using the Page Setup group of the Report tab and insert
the desired header and footer content using the Insert group of the Report
tab.
To Next Page
Loading...