EasyManua.ls Logo

Tascam DR-40 - System, File, and Operation Errors

Tascam DR-40
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
110 TASCAM DR-40
Message Meaning and response
File Not Found
Make Sys File
The system le is missing. This unit requires a system le for operation. When this message appears, press the
ENTER/MARK button to automatically create a system le.
Invalid SysFile
Make Sys File
The system le required to operate this unit is invalid. When this message appears, press the ENTER/MARK button
to automatically create a system le.
Invalid Card
Change Card
Something might be wrong with the card. Change the card.
Write Timeout
Writing to the card timed out.
Backup les on the card to your computer, and format the card.
Card Full
The card has no remaining capacity. Erase unnecessary les or move them to your computer to make open space.
Layer too Deep
Folders can be created down to two layers. You cannot create a new folder inside the current folder.
Can't Divide
The position selected for divide is not suitable (too close to the beginning or end of a le).
Max File Size
The le is larger than the designated size or the recording time exceeded 24 hours.
File Full
The total number of folders and les exceeds 5000. Erase unnecessary les or move them to your computer.
Card Error
The card could not be handled properly. Replace the card.
Current File MP3
MP3 les cannot be divided.
File Protected
The le is read only and cannot be erased.
No Card
No SD card is in the unit. Install a recordable SD card.
No PB File
There is no le that can be played back. The le might be damaged.
No MUSIC File
There is no playback le, so DIVIDE and OVERDUB cannot be executed.
Cannot overdub!
See REC setting
You cannot overdub a WAV le with a sampling frequency of 96 kHz in MP3 format. Change the recording format to
WAV.
Using by Input
The MS decoder is being used on the input. To use it on monitoring, on the
REC MODE
screen, set
MS DECODE
to
OFF
.
Now DUAL REC
In dual recording mode, change the input level control setting on the
REC MODE
screen.
Now OVERDUB
The MS decoder cannot be used in overdubbing mode.
Virtual File!
Virtual les cannot be played back or added to playlists. To play the le back use FILE SWAP.
14 – Messages

Table of Contents

Other manuals for Tascam DR-40

Related product manuals