Tascam DR-40 - Dual Recording and File Naming

54 TASCAM DR-40
3 Press the (HOME) [8] button to end recording and
create the audio file.
To pause recording, press the RECORD [0] button.
Press the RECORD [0] button again to restart recording
in the same file. If you press the (HOME) [8]
button after pausing a recorded audio file up to the
moment that you paused recording is created.
NOTE
To avoid recording of the noise from pressing the RECORD [0]
button, the start of recording is delayed by 0.3 second (xed)
after the RECORD [0] button is pressed. (REC DELAY)
CAUTION
Noise may occur when recording with a microphone if the unit
is too close to the AC adaptor. In such a case, keep sucient
distance between the AC adaptor and the unit.
File names when recording in MONO/STEREO
TASCAM_0001.WAV
1: Set with the WORD item on the FILE NAME screen
2: Recording le base number
Simultaneously recording two files at
different input levels (DUAL REC)
This recorder can simultaneously record a second recording
at a dierent input level along with the regular recording. For
example, when recording with microphones, you can make an
ordinary recording with the input level set as high as possible
and simultaneously record at a slightly lower input level for
safety.
Two recorded les (one with higher input level and one with
lower input level) are saved individually
NOTE
Make the input level setting for the ordinary recording in
•
the usual manner (see “Preparing the recording inputs” on
page 46 and “Adjusting the input level” on page 49).
Dual recording and overdubbing cannot be used
•
simultaneously.
Eects cannot be used on the le recorded at a dierent
•
input level.
Enabling dual recording
1 Press the REC MODE button to open the REC MODE
screen.
4 – Recording