Tascam DR-40 - OVERDUB INPUT MUTE Function (During Playback); Solo Function

TASCAM DR-40 85
of le names. If le names are changed, this function will not
work.
OVERDUB INPUT MUTE function (during
playback)
SEPARATE MODE
Press the 3/4 [SOLO] button to switch between the input
sound and the 3/4 track playback sound.
After overdubbing, you can use this to listen to the recorded
le.
MIX MODE
Press the 1/2 [SOLO] button to mute the input sound.
Solo function
Press and hold the 1/2 [SOLO] button or 3/4 [SOLO] button to
enable the solo function.
Use for projects that have been recorded in 4-channel mode
and in other cases when multiple les are being played back
to monitor only one of the les.
You can check the solo status with the track status indications.
6 – Playback