Tascam DR-40 - Removing the Card; Card Write Protection

TASCAM DR-40 39
Removing the card
1 Open the SD slot cover on the right side panel.
2 Press the SD card in gently and then release it to allow
it to come out.
CAUTION
Do not remove the SD card from the unit when it is
•
connected to a computer by USB.
SD cards that meet SD or SDHC standards can be used with
•
this unit.
A list of SD cards that have been conrmed to work with
•
this unit can be found on our website (http://tascam.com/).
Card write protection
SD cards have protect switches that prevent writing new data
to them.
Unprotected Protected
If you slide the protect switch to the “LOCK” position, le
recording and editing is not possible. Move the switch to the
unlocked position in order to record, erase and otherwise edit
data on the card.
3 – Preparation