Quick Start Guide
Try recording and playback with TASCAM DR-40.
The unit contains a factory-installed SD card, and will by
default produce 44.1 kHz, 16-bit WAV les.
Higher-quality or longer les can be produced using other
recording settings. See “Selecting file format, sampling
frequency, and maximum file size” for details on page 45.
1 Install batteries in the battery compartment on the
back of the unit. Fit them to the + and – marks shown in
the compartment.
2 Turn on, and various setting information will be
displayed.
Press the (HOME) [8] button until the unit is
turned on, and then release it.
CAUTION
The rst time you use the unit, a built-in clock setting screen
will appear.
Press the . or / button to move the cursor
(highlighted portion), and adjust the date and time
using the + or – button. Then press the ENTER/MARK
button to set.
To Next Page
