3. Fasten the HALO front fixing screw (24-01-017) and pin (24-01-016). Do not apply any tightening
torque.
4. Please note that the HALO front fixing screw (24-01-017) shall be on the left side and the HALO front
fixing pin (24-01-016) shall be on the right side.
5. Do not apply any tightening torque. Screw the HALO front fixing screw (24-01-017) until the screw’s
under-head gets in contact with the plane of the counterbore on the front bracket. At this point do
not apply any tightening torque but loose the HALO front fixing screw (24-01-017) one turn
(counterclockwise).
6. Place the assembly obtained at point 3 on the chassis.
To Next Page
