7. Fasten the two shoulder bolts (24-01-033). Do not apply any tightening torque. Screw the bolts until
the screw’s underhead gets in contact with the plane of the counterbore on the HALO foot. At this
point do not apply any tightening torque but loose the bolt one turn (counterclockwise).
8. Fasten the two M12X55 bolts. Do not apply any tightening torque. Screw the bolts until the screw’s
underhead gets in contact with the plane of the counterbore on the HALO foot. At this point do not
apply any tightening torque but loose the bolt one turn (counterclockwise).
To Next Page
