9. Fasten the two M12X30 bolts. Do not apply any tightening torque. Screw the bolts until the screw’s
underhead gets in contact with the plane of the counterbore on the HALO foot. At this point do not
apply any tightening torque but loose the bolt one turn (counterclockwise).
10. Fasten the six NAS6207-12 bolts. Do not apply any tightening torque. Screw the bolts until the screw’s
underhead gets in contact with the plane of the counterbore on the front bracket. At this point do
not apply any tightening torque but loose the bolt one turn (counterclockwise).
To Next Page
