Data Input/Output
3- 226
CSA7000B Series & TDS7000B Series Instruments User Manual
Use the procedure that follows to recall a setup to the instrument. Remember that
recalling a setup replaces the existing setup, which is lost.
Overview To recall your setup Control elements and resources
Prerequisites 1. The inst rum ent must be powered up. You must have
access to a setup saved by the instrument.
Note. This procedure does not make the setup active.
See Powering On the Instrument on page 1--9.
Display the
setups control
window
2. From the toolbar, touch Setups and select the Recall
Setups tab of the Setups control window.
Recall the setup 3. Touch the number of the setup that you want to recall.
The current instrument setup is overwritten.
Recall setup
from a file
4. To display the Recall Instrument Setup dialog, from the
Recall Setup control window, touch Recall.
The Recall Instrument Setup dialog allows navigation to
directories, lists setup files in the directory, and provides
for selection of a setup file.
Find the
source
directory
5. Use the Look in: drop-down list and buttons to navigate
to the directory, which contains a setup that you want to
recall.
To Recall Your Setup
To Next Page
Loading...
Need help?
General
