Tektronix CSA7404B User Manual

Appendix C: Menu Bar Commands
CSA7000B Series & TDS7000B Series Instruments User Manual
C-15
Utilities Commands
Table C--12 lists the commands available from the Utilities menu.
Table C- 12: Utilities menu commands
Menu Submenu Function
Tek Secure Erase Erases all setup and reference memory
Set Time & Date Displays a menu that you use to set the instrument date and time
GPIB Configuration Displays a control window that you use to set the GPIB talk/listen mode and the
bus address
LAN Server Status Displays the server status window that allows you to turn the server on and off
External Signals Choose the source and polarity of the AUX OUT signal
C
h
t
h
i
t
l
t
l
l
k
f
W
h
h
t
h
Choose the intern
a
lor
a
ne
x
tern
a
l
c
lo
c
kre
f
eren
c
e.
W
hene
v
er
y
ou
c
h
a
nge the
reference, you must perform a signal path compensation, see page 3--160.
Instrument Calibration Displays a window that you use to perform signal path compensation and, if in
service mode, instrument calibration
Instrument Diagnostics Displays a window that you use to run instrument diagnostics and view the
diagnostic status and error log. If errors are displayed, refer the instrument to
qualified service personnel
1
.
Multipurpose Knobs Deassign Multipurpose
Knobs
Momentary Readouts
Always Show Readouts
Never Show Readouts
Readout Setup. . .
Deassigns the multipurpose knobs from their current function
Set the multipurpose knob readouts to display momentarily, always, or never
Displays and allows you to set the time the momentary readouts are displayed
User Preferences Displ ays a window that you use to enable prompts before the instrument
performs requested actions (autoset, autoset undo, default/recall setup,
overwrite/del ete setup, or delete reference waveform), set keypad trigger level
defaults, select whether horizontal scale or sample rate is held constant when
you change record length, and select the type of measurement annotations
Option Installation Displ ays a window that you use to enable optional features and external
applications
1
If error code 512 is displayed, from the Utilities/Instrument Calibration menu run Signal Path Compensation, and then
from the Utilities/Instrument Diagnostics menu run the diagnostics.

Tektronix CSA7404B Specifications

General

Brand	Tektronix
Model	CSA7404B
Category	Measuring Instruments
Language	English