Installation
CSA7000B Series & TDS7000B Series Instruments User Manual
1-17
7. Use the arrow down key to highlight Onboard LAN in the P eripheral
Configuration screen, and then press Enter.
8. Use the arrow up or down key to highlight Enabled, and then press Enter.
9. Press the F10 key to save and exit. Confirm the Save of Configuration
changes when you are prompted on screen.
10. Use the Windows network setup utility to define the instrument as a network
client and configure it for your network. You can find the network setup
utility in the Windows Start menu if you select Settings > Control Panel
and then double-click Network. Consult your network administrator for
specific instructions to make these settings.
NOTE. If you want to disable network access for the instrument, perform the
above procedure except substitute Disabled for the command listed in step 8. The
instrument will boot faster with network access disabled.
Setting up a Dual Display
Use the following steps to set up the instrument for dual display operation. You
can operate the instrument while having full use of Windows and other applica-
tions on the external monitor.
To Next Page
Loading...
Need help?
General
