G10 Installation Guide 7.13.2 88
5
Connect G10 to the Monitored Network
Rev. 005-140228
2. After the cables are connected, verify that the ACT and LNK LEDs are ON.
3. Call Tektronix Service and Delivery to confirm the successful G10 installation
(refer
to page 2).
Table 5.6 - 10G Ethernet Connections - Optical Taps/Splitters
Monitored Network G10 10G Ethernet Connections
Monitored Interface 1 “Link 1” A Tap (TX) 10GbE 1 RX (right)
B Tap (RX) 10GbE 2 RX (right)
Monitored Interface 2 “Link 2” A Tap (TX) 10GbE 3 RX (right)
B Tap (RX) 10GbE 4 RX (right)
Tektronix Communications | For Licensed Users | Unauthorized Duplication and Distribution Prohibited
To Next Page
Loading...