Tektronix GeoProbe G10 Installation Guide

G10 Installation Guide 7.13.2 78 
5
Connect G10 to the Monitored Network
Rev. 005-140228
Optical Taps/Splitters (IIC200)
Perform the following to connect Ethernet cabling to the monitored network using optical taps/
splitters.
Step Action
1. Use Figure 5.2 and Table 5.2 to connect monitored network cables using
optical taps or splitters to the IIC200 Ethernet connections. In this
configuration the TX ports are not used.
Figure 5.2 - G10 Ethernet Connections - Optical Taps/Splitters
B
OUT
A
IN
A
OUT
B
IN
A TAP
TX
B TAP
RX
B
OUT
A
IN
A
OUT
B
IN
A TAP
TX
B TAP
RX
Tx
Rx
Monitored
Node A
Monitored
Node B
A IN
B OUT
A OUT
B IN
A TAP B TAP
TX RX
Monitored Interface
"Link 3"
Monitored Interface
"Link 4"
Optical Tap
B
OUT
A
IN
A
OUT
B
IN
A TAP
TX
B TAP
RX
Monitored Interface
"Link 1"
Optical Tap
Optical Tap
Optical Tap
GbE 1
GbE 2
1/10GbE5
1/10GbE6
Tx
Rx
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
Tx
Rx
Rx
Tx
B
OUT
A
IN
A
OUT
B
IN
Monitored Interface
"Link 2"
Optical Tap
A TAP
TX
B TAP
RX
GbE 3
GbE 4
1/10GbE7
1/10GbE8
IIC200
Ports
Tektronix Communications | For Licensed Users | Unauthorized Duplication and Distribution Prohibited

Tektronix GeoProbe G10 Specifications

General

Brand	Tektronix
Model	GeoProbe G10
Category	Accessories
Language	English