Performance Verification
4-18 SPG600 & SPG300 Sync Pulse Generators Service Manual
13. On the digital audio monitor front panel, press the MENU button to display the
Top menu.
14. Select Inputs from the Top menu
15. Select CH1-2 input: BNC-unbalanced from the submenu.
16. On the digital audio monitor front panel, press the CLEAR MENU button to
clear the menu.
17. On the digital audio monitor front panel, press the CH STATUS button to
display Channel Status view.
18. Check that no CRC errors appear on the monitor.
19. On the digital audio monitor front panel, press the AUDIO button to display
the Audio/Session view.
20. Verify that the digital audio monitor bar graphs show both Channel 1 and
Channel 2 at -20 dBFS.
21. Change the BNC cable connection from AES 1+2 connector to the AES 3+4
connector on the sync pulse generator.
22. Repeat steps 17 through 20.
23. Change the BNC cable connection from AES 3+4 connector to the AES 5+6
connector on the sync pulse generator.
24. Repeat steps 17 through 20.
25. Change the BNC cable connection from AES 5+6 connector to the AES 7+8
connector on the sync pulse generator.
26. Repeat steps 17 through 20.
27. Disconnect the BNC cable from the sync pulse generator and digital audio
monitor.
To Next Page
Loading...
Need help?
General
