Teledyne RIVERPRO - MQ - Streaming Download; MY - Y-Modem output

October 2017 RiverPro and RioPro ADCP Guide
Page 94
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
CW – Output the Last Stored Ensemble
Purpose Requests the most recently stored ensemble for output.
Format CW
Recommended Setting. Use the WinRiver II software - Data Recovery.
Description Recalls the most recently stored ensemble for output. This command is only valid during
a deployment when recording is enabled and will give an error message until valid data is
available. The CW command is available for PD0 output formats, and follows the CF com-
mand setting for binary or Hex-ASCII output.
CZ – Put the system to sleep
Purpose Tells the RiverPro/RioPro to power down.
Format CZ
Recommended Setting. This command should be used whenever batteries have been connected and
commands to start a deployment are not sent.
Description Sending the CZ-command powers down the RiverPro/RioPro. RiverPro/RioPro pro-
cessing is interrupted and the RiverPro/RioPro goes in the STANDBY mode (RAM is
maintained).
If the RiverPro/RioPro is running a sensor test under battery power, a fully charged battery
will be discharged in a few days.
>cz
Going to sleep