October 2017 RiverPro and RioPro ADCP Guide
Page 110
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
PD – Set Output Format
Purpose Selects the type of ensemble output data structure.
Format PDn
Range n = 0, 1 (0=ensemble; 1= TRDI use only)
Default PD0
Recommended Setting. Use the default setting for this command.
Description PD0 sends the real water-current data set.
PS – Display System Parameters
Purpose Displays the RiverPro/RioPro system configuration data.
Format PSn
Range n = 0, 3 (see description)
Recommended Setting. Use as needed.
Description See below.
PS0 – System Configuration
PS0 sends the RiverPro/RioPro hardware/firmware information. For example, the output may look like
this:
>ps0
System: RioPro
Serial Number: 2
Frequency: 1228800 Hz
Transducer Type: PISTON
Beam Angle: 20 Degrees
Beam Pattern: CONVEX
Vertical Beam: NONE
Sensors:
Temperature: DS18b20 1-Wire
Heading/Pitch/Roll: RDI (ISM)
GPS: Internal DGPS
CPU Firmware: 56.02 FD0i3
FPGA Version:7.00.002 [0x7002]
Board Serial Number Data:
BB 00 00 05 0F F9 36 28 DS18B20 TMP SNS
42 00 00 01 A1 12 70 23 XDR717-1150-00B
D6 00 00 01 A5 91 14 23 PIO72B-2201-00A
08 00 00 01 A5 AC 34 23 DSP72B-2212-00C
73 00 00 01 52 D0 C2 23 END72B-2264-01A
86 00 00 01 B8 DD 4A 23 MUX72B-2265-00A
08 00 00 01 B8 F0 29 23 PER72B-2353-05B
8C 00 00 01 A1 58 13 23 RCV72B-2263-02A
>
To Next Page
Loading...
