Teledyne RIVERPRO - CK - Save Command Parameters to Flash; CR - Restore Command Defaults

October 2017 RiverPro and RioPro ADCP Guide
Page 80
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
4. Click Next and follow the on-screen prompts.
5. If the new version of firmware will not install, contact Customer Service for assistance.
6. After successfully upgrading the firmware, use BBTalk to test the RiverPro/RioPro.
Feature Upgrades
The feature upgrade installation program is used to install the Section-by-Section (SxS) feature upgrade
in a RiverPro/RioPro.
Contact your local sales representative if you are interested in upgrading the system.
The upgrade disk is specific to the unit for which it was ordered. DO NOT attempt to install
this feature for any other unit.
Many feature upgrades require the latest firmware version to be installed in the
RiverPro/RioPro. Update the firmware before installing a feature upgrade (see Firmware
Updates).
To install a feature upgrade:
1. Set up the RiverPro/RioPro as shown in Setting up the RiverPro/RioPro System.
2. Run the NGSPActivate.exe program to enable the Section-By-Section features.
If this feature was ordered with the system, it will already be installed. For field upgrades, the
file can be renamed by TRDI, for example to RR_SNxxx.exe where xxx is the RiverPro/RioPro
ADCP’s serial number and will be e-mailed.
Figure 24. Installing Feature Upgrades
3. Click the Activate button. Once the feature has been installed, exit the NGSPActivate program.
4. Using BBTalk send the OL command (see OL – Display Feature List) to verify the feature upgrade
has been installed.