EasyManuals Logo

Tellabs 7300 Series User Manual

Tellabs 7300 Series
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
System Manual 5. Installation
76.7300FP11/2, Rev A 8/09 Page 2-79
Save Configuration __ 1. Enter the following command to save the current configuration into a
startup file:
t7300-tlab7300# write startup-config
System response:
Write operation [Complete]
Synchronize System Time and Date via SNTP
5.78 Follow the steps in this section to set up SNTP on the NE.
Set Up Simple Network Time
Protocol (SNTP)
__ 1. Enter the following command to enter Global configuration mode:
t7300-tlab7300# configure terminal
__ 2. Enter the following command to enter SNTP mode:
t7300-tlab7300(config)# sntp
__ 3. Enter the following command to enable the SNTP feature:
t7300-tlab7300(config-sntp)# set sntp client enabled
__ 4. Enter the following command to configure the SNTP server attributes:
t7300-tlab7300(config-sntp)# set sntp unicast-server ipv4
xxx.xxx.xxx.xxx [{primary|secondary}]
Where:
xxx.xxx.xxx.xxx = IP address of the SNTP server.
__ 5. Enter the following command to display the status of SNTP:
t7300-Tellabs(config-sntp)# show sntp status
System response:
sntp client is enabled
current sntp client version is v4
current sntp client addressing mode is unicast
sntp client port is 123
__ 6. Enter the following command to exit from Configuration mode:
t7300-Tellabs(config-sntp)# end
__ 7. Enter the following command to display the system date and time:
t7300-Tellabs# show clock
System response:
Tue Jul 28 2009 10:41:39 EST
Time Zone: EST UTC-05:00
Daylight Savings: DISABLED
Daylight Savings Time: EDT UTC-04:00

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tellabs 7300 Series and is the answer not in the manual?

Tellabs 7300 Series Specifications

General IconGeneral
BrandTellabs
Model7300 Series
CategorySwitch
LanguageEnglish

Related product manuals