Tellabs 7300 Series User Manual

5. Installation System Manual
Page 2-80 8/09 76.7300FP11/2, Rev A
Create New Users
5.79 Follow the steps in this section to create a new user and delete the default
password. You must have an A8 privilege code to enter the commands below.
__ 1. Enter the username command to create a new CLI user account:
username <user-name> password <passwd> [privilege
{a0|a2|a4|a6|a7|a8>} [session-timeout <0-99>] [passwordaging
<0-255>] [password-update <0-60>] [password-expired-login <0-5>]
[status {enabled | password-aged | disabled}]
Example:
username tester1 password Tlab7300 privilege a8 session-timeout
30 password-aging 30 password-update 25 password-expired-login 3
status enabled
__ 2. View the configured users by entering the following command. (Note
this is in the Global configuration mode and the user must be A8 to
view all users configured on the system. A4 and A6 users can only
view their own attributes, and A2 users cannot perform this command.)
t7300-Tellabs(config)# show username
System response:
UserName: tester1
Account Configuration
Variable Value
______________________________
command privilege A2
session-timeout 0
password-aging 1
password-update 0
password-expired-login 5
status Enabled
UserName: tellabs
Account Configuration
Variable Value
command privilege A8
session-timeout 0
password-aging 1
password-update 0
password-expired-login 5
status Enabled
__ 3. Enter the following command to configure global user policy on the
NE.
t7300-Tellabs(config)# username sys-config
System response:
username sys-config [login-tries<0-9>][suspend-time<0-300>]
[password-complexity {enabled|disabled}]
[account-timeout<0-365>][password-count<0-10>]

Tellabs 7300 Series Specifications

General

Brand	Tellabs
Model	7300 Series
Category	Switch
Language	English