5. Installation System Manual
Page 2-54 8/09 76.7300FP11/2, Rev A
Install the Assembled Power Converter Tray in the Rack
5.34 The 7300 Power Converter Tray is designed to be installed in a 19 inch
rack immediately below the Tellabs 7345 Switch or the Tellabs 7325 Switch. If the
NE is installed in a NEBS 23 inch rack or an ETSI rack, additional brackets must
be installed on the Tray before mounting it in the rack.
__ 1. If necessary, mount the adapter brackets to the Power Converter Tray
using the screws provided in the mounting hardware kit.
The following adapter kits are available for the Power Converter Tray:
- 81.73NEBS-B-R6 23 inch 1RU NEBS Mounting Adapter Kit
- 81.73ETSI-B-R6 21 inch 1RU ETSI Mounting Adapter Kit
__ 2. Mount the 7300 Power Converter Tray directly below the Tellabs 7345
Switch or Tellabs 7325 Switch (Tellabs 7345 shown below). Route the
AC power cables out the front of the Tray on the left and the DC power
cables out the front of the Tray on the right. Refer to Figure 5.8,
page 2-54.
After you have grounded the shelf and installed the modules, there are
steps to connect the DC power cables to the Tellabs 7325 Switch or
the Tellabs 7345 Switch. Refer to Connecting the DC Power Cable
From the AC Power Converter Tray (Tellabs 7325 Switch), page 2-60
and Connecting the DC Power Cable From the AC Power Converter
Tray (Tellabs 7345 Switch), page 2-60.
Figure 5.8 Mount Tellabs 7300 Power Converter Tray in Rack
Caution:
Do not connect the AC power until the Power Converter Tray is mounted and the
DC power cable is securely connected to the Power Converter.
To Next Page
Loading...
Need help?
General
