Tellabs 7300 Series User Manual

5. Installation System Manual
Page 2-78 8/09 76.7300FP11/2, Rev A
__ 5. Enter the following command to view the alarm profile:
t7300-# show alarm-profile detail profile 1 alarm-name tlabEqPowerFeedBNotif
System response:
Alarm Profile 1
---------------------------------------------------
Oid: 1.3.6.1.4.1.1397.2.33.15.0.1.11
Name: tlabEqPowerFeedBNotif
Severity SA Loc Condition
not-alarmed nsa ne-rx standing
Note: If you need to change the IP address, refer to the Tellabs 7300 CLI
Operations Manual.
5.76 To set the system time and date manually, go to Set System Time and
Date Manually, page 2-78.
To use Simple Network Time Protocol (SNTP) to synchronize the time and date,
go to Synchronize System Time and Date via SNTP, page 2-79.
Set System Time and Date Manually
5.77 Follow the steps in this section to change the system time and date and
enable Daylight Savings Time.
Change System Time and
Date
__ 1. Enter the following command to change the system time and date to
your current time and date:
t7300-tlab7300# clock set hh:mm:ss dd mmm yyyy
Where:
hh = Hour.
mm = Minute.
ss = Second.
dd = 2 digit day.
mmm = Month (Jan, Feb, Mar, Apr, May, Jun, Jul, Aug,
Sep, Oct, Nov, Dec).
yyyy = Four digit year.
Enable Daylight Savings
Time
__ 1. Enter the following command to enable Daylight Savings Time:
t7300-tlab7300# daylight savings
__ 2. Enter the following command to verify that Daylight Savings Time is
implemented:
t7300-tlab7300# show clock
System response:
Feb 26 16:38:24 2009
Daylight Savings: ENABLED
Time Zone: UTC
NTP Peer Timing Source:
NTP Peer Alternate:
Timing Source State:

Tellabs 7300 Series Specifications

General

Brand	Tellabs
Model	7300 Series
Category	Switch
Language	English