EasyManuals Logo

Tellabs 7300 Series User Manual

Tellabs 7300 Series
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
System Manual 5. Installation
76.7300FP11/2, Rev A 8/09 Page 2-75
Initializing the Tellabs 7300 NE
5.74 Initialize the Tellabs 7300 NE by performing the following steps:
__ 1. Power up Tellabs 7300 NE.
__ 2. Verify the following module LED states:
Tellabs 7345 Switch:
__ 10G Switch module: Active=green, Power=green, Fault=off
__ Fan Tray: Power=green
__ PSU: +12V=green
__ CMCC: Active/Standby=green, Power/Status=green
Tellabs 7325 Switch:
__ Active=green, Power=green, Fault=off
__ PSU: +12V=green
Complete step 3, page 2-75 if you have an Ethernet connection via the
MGT1 port or skip to step 4, page 2-75 if you are connected to the system
via the CT port.
__ 3. Telnet to the default IP address (10.0.0.1) by entering the following
command at the prompt:
Telnet 10.0.0.1
Continue with step 5, page 2-75.
__ 4. Connect to the Command Language Interface (CLI) and verify the user
prompt is seen. Initial bring-up may occur on any of the interfaces
(local serial port, local Ethernet port).
__ 5. Log in to the Tellabs 7300 NE by entering the following commands:
Login: [login_name]
Password: [password]
Where:
login_name = Login name.
password = User password.
__ 6. Verify the software load by entering the following command:
show system information
System response:
System ID : Tellabs
System Contact : Tellabs Technical Assistance at 1.800.443.55
55
System Location : Tellabs Operations, Inc, USA
System Site : TELLABS
System Configuration : 10G-Switch
System Power Supply Redundancy : Redundant
System Switch Redundancy : Non-Redundant
Logging Option : Console Logging
Login Authentication Mode : Remote
Config Save Status : Not Initiated
Remote Save Status : Not Initiated
Config Restore Status : Successful
Software Version : FP1.1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tellabs 7300 Series and is the answer not in the manual?

Tellabs 7300 Series Specifications

General IconGeneral
BrandTellabs
Model7300 Series
CategorySwitch
LanguageEnglish

Related product manuals