EasyManuals Logo

Tellabs 7300 Series User Manual

Tellabs 7300 Series
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
System Manual 6. Maintenance
76.7300FP11/2, Rev A 8/09 Page 2-89
__ 2. Enter the following command to exit Global Configuration mode:
t7300-tlab7300(config)# end
__ 3. Enter the following command to display the current configuration of the
scheduled backup:
t7300-tlab7300# show scheduled backup
System response:
Scheduled Backup is Active
Backup Location: flash1
Overwrite Startup is ENABLED
Sheduled Backup Interval: 1 Day
Backup Start: 2009-2-21,0:15:0.0,+0:0
Restore a Local Backup
6.07 Restore a local backup by performing the following steps:
__ 1. Enter the following command at the CLI prompt to save the current
configuration into a startup file:
t7300-tlab7300# write startup-config
System response:
Write operation [Complete]
__ 2. Enter the following command to copy the configuration from system
flash to startup-config:
t7300 # copy flash:<file_name> startup-config
__ 3. Enter the following command to reboot the Tellabs 7300 NE from the
restored file:
t7300 # reload
Caution:
This procedure is traffic affecting.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tellabs 7300 Series and is the answer not in the manual?

Tellabs 7300 Series Specifications

General IconGeneral
BrandTellabs
Model7300 Series
CategorySwitch
LanguageEnglish

Related product manuals