EasyManuals Logo

Tellabs 7300 Series User Manual

Tellabs 7300 Series
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
6. Maintenance System Manual
Page 2-90 8/09 76.7300FP11/2, Rev A
Restore a Remote Backup
6.08 Restore a remote backup by performing the following steps:
__ 1. Enter the following command at the CLI prompt to save the current
configuration into a startup file:
t7300-tlab7300# write startup-config
System response:
Write operation [Complete]
__ 2. Enter the following command to copy the configuration from a remote
site to startup-config:
t7300 # copy tftp://xxx.xxx.xxx.xxx/<file_name> startup-config
Where: xxx.xxx.xxx.xxx = IP address of network and host.
__ 3. Enter the following command to reboot the Tellabs 7300 NE from the
restored file:
t7300 # reload
Upgrade the System Software
6.09 Upgrade the Tellabs 7300 NE software by performing the following steps:
__ 1. Connect to the Command Language Interface (CLI) and access a CLI
prompt.
__ 2. Enter the following command at the CLI prompt:
t7300-tlab7300#
manage upgrade check tftp://xxx.xxx.xxx.xxx/CPESWapp.cramfs
Where: xxx.xxx.xxx.xxx = IP address of network and host.
__ 3. Enter the following command at the CLI prompt:
t7300-tlab7300#
copy tftp://xxx.xxx.xxx.xxx/CPESWapp.cramfs flash:/tmp/upgrade
Where: xxx.xxx.xxx.xxx = IP address of network and host.
System response:
t7300-# Copied tftp://xxx.xxx.xxx.xxx/CPESWapp.cramfs flash:/tmp/upgrade
__ 4. Enter the following command at the CLI prompt:
manage upgrade install
Caution:
This procedure is traffic affecting.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tellabs 7300 Series and is the answer not in the manual?

Tellabs 7300 Series Specifications

General IconGeneral
BrandTellabs
Model7300 Series
CategorySwitch
LanguageEnglish

Related product manuals