EasyManua.ls Logo

Texas Instruments TI-82 STATS - Page 195

Texas Instruments TI-82 STATS
442 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Lists 11–13
826886~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:33 PM Printed: 10/27/05 2:50
PM Page 13 of 18
Before using Select(, follow these steps.
1. Create two list names and enter the data.
2. Turn on a stat plot, select
"
""
" (scatter plot) or Ó
ÓÓ
Ó (xyLine), and
enter the two list names for
Xlist: and Ylist: (Chapter 12).
3. Use ZoomStat to plot the data (Chapter 3).
To select data points from a scatter plot or xyLine plot, follow
these steps.
1. Press y [
LIST] ~ 8 to select 8:Select( from the LIST OPS
menu. Select( is pasted to the home screen.
2. Enter xlistname, press ¢, enter ylistname, and then press ¤
to designate list names into which you want the selected data
to be stored.
3. Press Í. The graph screen is displayed with
Left Bound? in the bottom-left corner.
4. Press } or (if more than one stat plot is selected) to move
the cursor onto the stat plot from which you want to select
data points.
5. Press | and ~ to move the cursor to the stat plot data point
that you want as the left bound.
Before Using
Select(
Using Select( to
Select Data
Points from a
Plot

Table of Contents

Other manuals for Texas Instruments TI-82 STATS

Related product manuals