Textron Jacobsen InCommand PGM 22 - Page 143

ACCESSORIES
4157082 First Edition 10-15
10
Disassembly—Grooved Segmented Roller
See Figures 10-22 and 10-23.
Figure 10-22
1. Remove hex-jam, nylon-insert nut (10) from the roller
shaft (2) while holding the nut (1) at the other end of
the shaft.
2. Remove short spacer (9) and roller segment
assembly (8).
3. Remove long spacers (5 and 7) and roller segment
assemblies (4 and 6).
4. Remove short spacer (3) from roller shaft (2).
Figure 10-23
NOTE
All three roller segment assemblies are disassembled in
the same way.
5. Remove grease seals (11 and 15), ball bearings
(12 and 16) and spacer (13) from the roller segment
(14).
Assembly—Grooved Segmented Roller
See Figures 10-24 and 10-25.
Figure 10-24
NOTES
• All three roller segments are assembled in the same
way.
• Always use new grease seals for installation.
1. Install ball bearing (2) and a new grease seal (1) in
one end of the roller segment (4).
TN0251
1
TN0251
2
3
4
5
6
7
8
9
10
TN0252
11
TN0252
13
14
16
15
12
TN0252
1
TN0252
3
4
6
5
2