Appendix B RS-232 Commands
B-17
push
button
button = | run | menu | enter | help | up | down | left | right |
This command is used to simulate pressing the Model 48C front panel pushbuttons. In
the example below, the push command is used in conjunction with the screen command
to view the Main Menu. Note that the instrument is in the Run screen initially. Also note
that sending just the button command receives the same response.
Send: "push menu" or Send: "menu"
Receive: "push menu ok" Receive: "menu ok"
Send: "screen"
Receive: "MAIN MENU: 10:25"
">RANGE "
" AVERAGING TIME "
" CALIBRATION FACTORS "
motor
This command reports the motor speed. The example below shows that the motor speed
is 100%.
Send: "motor"
Receive: "motor 100%"
bright
This command reports the display’s level of brightness. The example below shows that
the level of brightness is 75%.
Send: "bright"
Receive: "bright 75%"
To Next Page
Loading...
Need help?
General
