Operating Instructions
126
9. The “New Setpoint Is XX” Screen briefly appears. See
Figure 92.
10. The Standard Display appears with setpoint changed to the
new setpoint. See Figure 92.
NOTE: Pressing the E
XIT soft key at any point will return to
the Standard Display.
NOTE: If no keys are pressed for 30 seconds while in the
Named Product Changer Screens, the HMI will return to the
Standard Display.
Operating Instructions
126
9. The “New Setpoint Is XX” Screen briefly appears. See
Figure 92.
10. The Standard Display appears with setpoint changed to the
new setpoint. See Figure 92.
NOTE: Pressing the E
XIT soft key at any point will return to
the Standard Display.
NOTE: If no keys are pressed for 30 seconds while in the
Named Product Changer Screens, the HMI will return to the
Standard Display.
To Next Page
