Operating Instructions
60
Electric Standby Operation
Model 50 units are equipped with Electric Standby. This
feature allows the unit to operate on electric power as well as
be powered by the standard diesel engine.
During Electric Standby operation, power to the unit is
supplied by an electric motor connected to a high voltage
power source. The required voltage is shown on a decal on the
unit’s electric power receptacle.
Electric Power Receptacle: The electric power receptacle
is used to connect the unit to an appropriate electric power
source for electric standby operation. The electric power
receptacle is located next to the HMI Control Panel. Make sure
the unit and the power supply are turned off before connecting
or disconnecting a power cord.
Figure 34: Electric Power Receptacle
WARNING: Units equipped with electric standby may
start at any time when the unit is connected to live
electric power and the controller is turned on.
CAUTION: Always turn the electric power supply off
when handling, connecting, or disconnecting high
voltage power cords.
CAUTION: Do not start the electric drive motor
unless the diesel engine is completely stopped.
Operating Instructions
60
Electric Standby Operation
Model 50 units are equipped with Electric Standby. This
feature allows the unit to operate on electric power as well as
be powered by the standard diesel engine.
During Electric Standby operation, power to the unit is
supplied by an electric motor connected to a high voltage
power source. The required voltage is shown on a decal on the
unit’s electric power receptacle.
Electric Power Receptacle: The electric power receptacle
is used to connect the unit to an appropriate electric power
source for electric standby operation. The electric power
receptacle is located next to the HMI Control Panel. Make sure
the unit and the power supply are turned off before connecting
or disconnecting a power cord.
Figure 34: Electric Power Receptacle
WARNING: Units equipped with electric standby may
start at any time when the unit is connected to live
electric power and the controller is turned on.
CAUTION: Always turn the electric power supply off
when handling, connecting, or disconnecting high
voltage power cords.
CAUTION: Do not start the electric drive motor
unless the diesel engine is completely stopped.
To Next Page
