Thermo King SB-210+ - Important Alarm Notes

Operating Instructions
86
7. After the alarm situation is resolved press the CLEAR key
to clear the alarm. To display the next alarm, press the
N
EXT key (see Figure 59).
NOTE: For additional information regarding the alarm
shown on the display press the H
ELP soft key. A help
message will appear.
Important Alarm Notes
• If an alarm will not clear, it may still exist. If the alarm is
not corrected, it will not clear.
• If an alarm cannot be cleared from the Main menu, the
C
LEAR key will not appear. These alarms must be cleared
from the Guarded Access Menus.
• All alarms must be viewed before any of the alarms can be
cleared.
• Check Alarm Code 96 (Low Fuel Level) is set when the
fuel level falls to 15%. The controller can be programmed
to set a shutdown Alarm Code 44 (Out of Fuel) when the
fuel level falls to 5%. Shutdown Alarm Code 44 can be
manually cleared with the C
LEAR key. In that case it
becomes a check alarm and the unit will continue to run
until it runs out of fuel (if it is not refilled). Alarm Code 96
and Alarm Code 44 are both automatically reset when the
fuel tank is refilled above 25%.
NOTE: Shutdown Alarm Code 44 reappears when it is
manually cleared from the Alarms Menu. However, it
changes to a check alarm so the unit will now start after
you exit the Alarms Menu.
Contact your supervisor or a Thermo King dealer for
information about alarm codes that will not clear.
Operating Instructions
86
7. After the alarm situation is resolved press the CLEAR key
to clear the alarm. To display the next alarm, press the
N
EXT key (see Figure 59).
NOTE: For additional information regarding the alarm
shown on the display press the H
ELP soft key. A help
message will appear.
Important Alarm Notes
• If an alarm will not clear, it may still exist. If the alarm is
not corrected, it will not clear.
• If an alarm cannot be cleared from the Main menu, the
C
LEAR key will not appear. These alarms must be cleared
from the Guarded Access Menus.
• All alarms must be viewed before any of the alarms can be
cleared.
• Check Alarm Code 96 (Low Fuel Level) is set when the
fuel level falls to 15%. The controller can be programmed
to set a shutdown Alarm Code 44 (Out of Fuel) when the
fuel level falls to 5%. Shutdown Alarm Code 44 can be
manually cleared with the C
LEAR key. In that case it
becomes a check alarm and the unit will continue to run
until it runs out of fuel (if it is not refilled). Alarm Code 96
and Alarm Code 44 are both automatically reset when the
fuel tank is refilled above 25%.
NOTE: Shutdown Alarm Code 44 reappears when it is
manually cleared from the Alarms Menu. However, it
changes to a check alarm so the unit will now start after
you exit the Alarms Menu.
Contact your supervisor or a Thermo King dealer for
information about alarm codes that will not clear.