Thermo King SB-210+ - Page 154

Alarm Codes
153
33 Check Engine RPM Report alarm at end of day. X
35 Run Relay Circuit
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
36 Electric Motor Failed to Run
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
37 Engine Coolant Level
Check coolant level, add as needed. Report alarm at end of
day.
X
38 Electric Phase Reversed
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
39 Water Valve Circuit
Manually monitor load temperature with independent
thermometer. Report alarm at end of day.
X
40 High Speed Circuit
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
Table of Alarm Codes
NOTE: Not all alarm codes are available with all microprocessor controllers or all revisions of software.
Code Description Corrective Action
Level Of
Action
Ok To Run Check Shut Down
Alarm Codes
153
33 Check Engine RPM Report alarm at end of day. X
35 Run Relay Circuit
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
36 Electric Motor Failed to Run
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
37 Engine Coolant Level
Check coolant level, add as needed. Report alarm at end of
day.
X
38 Electric Phase Reversed
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
39 Water Valve Circuit
Manually monitor load temperature with independent
thermometer. Report alarm at end of day.
X
40 High Speed Circuit
If unit is shutdown, repair immediately. Otherwise, report
alarm at end of day.
X
Table of Alarm Codes
NOTE: Not all alarm codes are available with all microprocessor controllers or all revisions of software.
Code Description Corrective Action
Level Of
Action
Ok To Run Check Shut Down