Operating Instructions
66
NOTE: Alarm Code 127 “Setpoint Not Entered” may be
generated if the + or - soft keys are used to change the
setpoint, but the Y
ES or NO soft keys are not used to
accept or decline the new setpoint.
5. The “Programming New Setpoint” Screen will appear. See
Figure 42.
6. The “New Setpoint Is XX” Screen briefly appears. See
Figure 42.
7. The Standard Display appears with setpoint changed to the
new setpoint. See Figure 42.
Operating Instructions
66
NOTE: Alarm Code 127 “Setpoint Not Entered” may be
generated if the + or - soft keys are used to change the
setpoint, but the Y
ES or NO soft keys are not used to
accept or decline the new setpoint.
5. The “Programming New Setpoint” Screen will appear. See
Figure 42.
6. The “New Setpoint Is XX” Screen briefly appears. See
Figure 42.
7. The Standard Display appears with setpoint changed to the
new setpoint. See Figure 42.
To Next Page
Loading...
