Topcon X14 - Using Guidelock Guidance Mode; Selecting an Existing Guideline

13.4. Using guidelock guidance mode
92
2.
Select / Guidelines Menu / Change Guidance
Mode, if necessary, to choose Center Pivot Lines .
3.
Select Create New Center Pivot .
4. Select GUIDELINE NAME.
5. Enter a name and confirm. Confirm the new guideline.
6. Drive around the center of the field. A pivot accuracy bar is
displayed to indicate the progress of guideline creation.
Once the system detects the arc, circular guidelines are created,
based on the width of the implement. Remember to consider the
turning circle of the vehicle and implement when driving the first
arc.
13.4. Using guidelock guidance mode
Guidelock is a coverage based guidance mode. It generates a curve
based on existing coverage, regardless of when that coverage was laid.
This is convenient if wanting to steer around a contour or field
boundary but you don’t want to create and save a curve, or if you
want to continue steering alongside some coverage that was treated
earlier that you did not save a curve for. This guideline method is
sometimes referred to as ‘free form’.
1.
Select / Guidelines Menu / Change Guidance
Mode, if necessary, to choose Guidelock Guidance Mode .
A guideline is generated that follows whichever path the vehicle
takes.
13.5. Selecting an existing guideline
Once guidelines have been created within fields, these are stored and
can be accessed on future jobs in the field.