53
Chapter 8 – Product Setup
8.1. Setting up the product database
Product definitions can be saved in one common area. This allows
common products to be used across a range of rate controllers
without having to enter each product name and rate repeatedly.
Pre-set rates, increments and product densities can be set up and saved
to be recalled in the appropriate rate controller.
The calibration factor for each product is assigned to each implement
tank or bin. This means, for example, that you could have urea saved
once with different calibration figures for each bin.
1.
Select Product . The Liquid Product Setup wizard is
displayed.
For each product, the following information must be defined:
l Rate increment: Defines how much the application rate will
change when the operator presses the application rate up/down
button. The rate can be changed by a fixed rate or by a percentage
of the rate set for Rate Preset 1. Refer to Application rate
increment type, page 22.
l Rate preset 1 / Rate preset 2: Defines preset application rates.
l Calibration factor: This is the number of pulses from the flow
meter per litre of liquid. This value can be viewed here but must
be set for each implement and product.
To Next Page
Loading...