Topcon X14 - Time;Date Setup

4.1. Setting the region
20
To set the language or decimal point format:
1.
Select User / Region / Language .
The following options are available:
Language
There is a choice of languages available.
Use the scroll bar, or slide a finger down the list, to see more
languages. Confirm the selection. The console will restart.
Note: The language may also be changed on the warning screen at
startup by selecting .
Decimal point format
A decimal point may be represented by a period (.) or a comma (,).
4.1.2. Time/date setup
The date information is used on the console for job start and end
dates, as shown on job reports. The current date is supplied from the
GPS signal.
Note: Both time and date will not work if there is no GPS signal.
To set date and time information:
1.
Select User / Region / Time/Date .
The following options are available:
Date format
l Day of the month first (12 August 2015)
l Month first (August 12 2015)
Time format
l Twelve hour time (2:30pm)
l Twenty four hour time (14:30)
Set current time
Current time (does not change automatically for daylight saving).
Note that -/+ will change time incrementally.