Topcon X14 - Chapter 3 - Quick Setup Guide; 3.1. Software Update Instructions; 3.2. Getting Started

15
Chapter 3 – Quick Setup Guide
This chapter provides a quick overview to installing software onto the
console, setting up the basics and operating the console.
WARNING: It is not recommended to operate the
console for the first time without reading the complete
manual to become familiar with all safety and
operational issues.
3.1. Software update instructions
Note: This procedure should not be necessary when receiving a new
console. It is only necessary if a software upgrade is required.
1. Insert the USB containing the upgraded software.
2.
Go to the Setup screen and select System / Utilities .
3. Select CONSOLE SOFTWARE UPGRADE.
Selecting this option displays a message that the console will
restart.
4. Confirm the message. The console will restart and load the
upgraded software.
The console will provide the option to restore all user data to the
state it was before the upgrade. WARNING: Selecting No will
delete all data saved on the console.
3.2. Getting started
To configure the system:
1. Connect a GPS receiver to the console.
2. Go to the Setup screen.
3.
Select System / GPS and select:
l The GPS receiver that is being used (see page 29).
l The Correction Source required (see page 31).