Topcon X14 - Page 34

3.2. Getting started
16
4. Once the system receives GPS data for the first time, it will
prompt for configuration of the local time. Accept the current
time or modify it to your local time.
5.
Select Vehicle / New and create a new vehicle profile
by selecting the appropriate model from the factory profile.
Check and if needed modify the geometry of the vehicle (see
page 42).
6.
Select Implement / New and create a new implement
profile by selecting the appropriate implement type. Check and if
needed modify the geometry of the implement (see page 48).
7. Go to the Operation screen.
8. Go to Select Field and create new Client, Farm and Field (see
page 77).
9. Go to New Job and create a new job (see page 85). The system is
now operational.
10.
To enable Auto Steering, go to Setup screen, System /
Features / Guidance / AUTO STEER (see page 95).
11. To enable Auto Section Control, go to Setup screen and:
l Create or load an implement.
l
In Implement / Section Control / Sections
configure the number of sections and their width (see page 50).
l
If required, change the section timing in Implement /
Section Control / Timing (see page 50).
l If required, configure a physical or virtual switchbox in
Implement / Section Control / Section Switch
(see page 51).