Topcon X14 - Page 130

17.1. Common error messages
112
Code Fault Action Page
U1065 Wheel angle sensor
calibration required.
A change of tires is a
common cause but is not
the only possible cause.
Confirm vehicle
measurements and then
recalibrate.
43
68
U1066 Compass calibration
required.
Calibrate compass. 67
U1067 New vehicle or new
steering controller
has been detected.
Recalibrate compass. 67
U1068 Vehicle profile does
not match steering
subsystem settings.
Confirm steering
subsystem is turned on.
Return to main setup
menu and reset vehicle
and steering.
42 - 45
U1069 Steering subsystem
steering wheel sensor
is not configured.
Contact dealer.
U1071 AES-25 average
power is greater than
the power limit.
Confirm load on AES-25
motor unit (for example
the steering column is too
heavy or the bushes or
bearings are worn).
Contact dealer.
U1072 AES-25 temperature
greater than the
temperature limit.
Turn off and allow to
cool down. If problem
persists contact the dealer.