HYDRAULIC DRIVE SYSTEM
6-136” & 40” Toro GrandStand Service Manual
6
Pump Drive Belt Replacement
Pump Drive Belt Removal
2. 40” Deck: Using a spring tool, remove the LH
extension spring from the deck anchor post (Fig.
422).
1. 36” Deck: Using a spring tool, remove the exten-
sion spring from the deck anchor post (Fig. 421).
3. Raise the machine so the underside of the chassis
can be accessed.
4. Remove the deck belt from the clutch pulley (Fig.
423).
Fig. 421 DSCN-2562a
Fig. 422 DSCN-2564a
Fig. 423 DSCN-2569a
5. Remove the extension spring from the drive idler
pulley assembly (Fig. 424).
Fig. 424 DSCN-2574a
To Next Page
Loading...
