Toro GrandStand 74534 - Height-Of-Cut (HOC) Handle Assembly Replacement; HOC Handle Assembly Removal

CONTROLS
4-1936” & 40” Toro GrandStand Service Manual
4
Height-of-Cut (HOC) Handle
Assembly Replacement
HOC Handle Assembly Removal
1. Positiontwoboardsunderthedeck,thenlowerthe
deckontotheboards(Fig.248).
3. Removethesnapringandwashersecuringthe
HOChandleassemblytotheframe(Fig.250).
Fig. 248 DSCN-3839a
2. Removetheboltandnutsecuringtheliftlink
assemblytothelowerendoftheHOChandle(Fig.
249).
Fig. 249 DSCN-3841a
Fig. 250 DSCN-3843a
4. RemovethenutssecuringtheHOCanchorboltto
theHOCplateassembly(Fig.251).
Fig. 251 DSCN-3848a