Toro GrandStand 74534 - Adjusting the Left Side Front-To-Rear Mower Pitch

MOWER DECK
7-50 36” & 40” Toro GrandStand Service Manual
7
Adjusting the Left Side Front-to-Rear Mower
Pitch
1. Positiontheleftbladefront-to-rear.
2. MeasuretheleftbladeattheAlocation,froma
level surface to the cutting edge of the blade tip and
record this measurement (Fig. 717).
3. MeasuretheleftbladeattheBlocation,froma
level surface to the cutting edge of the blade tip and
record this measurement (Fig. 717).
4. Themowerbladeshouldbea1/4”to3/8”(6to
10mm)loweratpositionAthanatpositionB(Fig.
717).Ifitisnotcorrect,proceedtothefollowing
steps.
1. Measureherefromthe 2.MeasureatA&B
blade to a hard surface
5. Loosen the nut on the upper chain bolt and the jam
nutontheadjustmentbolt(Fig.718).
6. Usetheadjustmentbolttoachieve1/4”to3/8”(6to
10mm)lowerinfrontatAthanintherearatB(Fig.
718).
7. Tighten the nut on the upper chain bolt and the jam
nut on the adjustment bolt.
Fig. 717 g.84G012784
A. Measure here at the D. Front chain
center of the swivels E. Rear chain
(cntr-to-cntr length) F. Adjustment bolt
B. Swiveljamnuts G. JamNut
C. Front swivel H. Upper chain bolt
Fig. 718 g.83G012739
A
B
E
F
G
H
C
B
D